Harley Davidson Exhaust Nut Torque

Torque Specs Harley Exhaust Flange. Repeat on the rear cylinder. This swivel extension and socket combination allows you to easily reach the rear axle nut.

harley davidson dyna super glide sport gta 5 harley davidson dyna ultra glide harley davidson dyna super glide fxd harley davidson dyna switchback zubehoer harley davidson dyna super glide for sale canada harley davidson dyna super glide sport usata harley davidson dyna super glide sport price harley davidson dyna super glide usata

Torque Specs For Exhaust Studs Harley Davidson Forums

Exhaust Header Torque Settings Harley Davidson Forums

Black Loose Cannon Slip On Muffler Brand Firebrand Year Make Model 2015 2017 Harley Davidson Harley Davidson Pictures Harley Davidson India Harley Exhaust

2016 Harley Davidson Street Glide Torque Specs

04 Dyna Engine Install Torque Specs Harley Davidson Forums

HARLEY -DAVIDSON Manufacturer Part Number.

Harley davidson exhaust nut torque. Id suggest removing mufflers first and getting the Service Manual 99501-08. The torque PROCEDURE requires you tighten the top nut to 9-18 INCH pounds and then final torque the bottom nut and then final tourqe the top nut. Facilitates loosening and tightening of hard to reach rear axle nut on HD baggers.

Additionally tighten the head pipe support bracket bolts as indicated in the exhaust manufacturers instructions. 16Torque the transmission pan support bracket to 13-15ft lbs. Harley Exhaust Nuts.

Insert the small end of a torque cone into each of the two exhaust pipe openings until the flange on the cones comes against the flange on the exhaust pipes. Remove the used HO2S gasket from sensor and install a new gasket to the HO2S gasket sold separately. 38 - 33 ft.

Need torque spec for rear. Tighten rear cylinder exhaust flange nuts. I recommend you check these nuts at the end of the first few rides and retorque as necessary.

Ad Fast Free Shipping on Orders Over 40. 14 - 10 ft. Step 6 Raise the exhaust pipes back up and thread the head bolts and rear mounting bolts into position.

Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary. Tighten the exhaust flange nuts evenly and to a torque of 60-80 inlbs. Rear axle nut and left side axle hex are 36 mm.